Home > Knowledge > Content

How to use the mechanical and physical properties of titanium during the processing of titanium plates and tubes

Dec 03, 2020

How to use the mechanical and physical properties of titanium during the processing of titanium plates and tubes  

(1) The elastic modulus of titanium is low relative to its tensile performance. Therefore, in the pressing and rolling operations, a larger rebound margin must be considered. It is precisely because of the lower modulus of elasticity that, in order to achieve the same degree of stability, the cross section of titanium parts is slightly larger than that of the same steel parts.   

(2) Titanium is easy to be machined, but it is necessary to consider its seizure tendency (larger than stainless steel) and low thermal conductivity. It is necessary to appropriately improve the commonly used machining technology and the design of the thread and bearing surface. At least there must be a rigid machine tool, sharp tools, slow speed, large cutting volume, and leave room for chip removal, and it is recommended to use a large amount of cooling lubricant.   

(3) The thermal expansion coefficient of titanium is 75% of carbon steel. When it is necessary to combine these two materials in equipment design and manufacturing, special attention should be paid to this point.   

(4) Because titanium is a kind of active metal, it is easy to combine with oxygen in the air when heated above 600℃, so it is generally not recommended to use titanium for a long time above this temperature.   

(5) When the temperature of industrial pure titanium exceeds 150~200℃, the mechanical strength decreases rapidly. 

(6) The diffusion rate of hydrogen in titanium is faster than that of oxygen. Therefore, before the thermal processing, the heating furnace used should have a micro-oxidizing atmosphere. This will produce a relatively thin oxide film, but it avoids the possibility of hydrogen. Deep pollution.   

(7) The softer industrial pure titanium plate is easy to be cold-formed after annealing; the harder industrial pure titanium and Ti2.5Cu require medium temperature processing, and the processing temperature for Ti6Al4V is preferably 600~700℃.   

(8) Composite plates can be obtained by explosive welding of thin titanium plates and thick steel plates, which can be used to manufacture high-pressure and high-temperature vessels and heat exchangers. However, it is not economically cost-effective to use it to replace overall titanium or suit-lined titanium plates.

Send Inquiry